Guide · Fishkeepers · 3 min read · Updated 17 November 2026
Moving a Marine or Reef Tank: What's Involved
Short answer
Moving a reef tank means boxing corals and invertebrates in oxygenated bags, keeping live rock wet and warm, draining and packing the sump and equipment, and preparing fresh salt water at the new address before the livestock goes back in. The aim is to keep temperature and salinity stable throughout. Marine and reef system moves start from £650 and larger systems are usually quoted after a survey.
Why reef tanks need extra care
A marine reef aquarium is one of the most demanding systems to move. Corals, anemones, clams and many invertebrates are far more sensitive than freshwater fish to changes in temperature, salinity and water chemistry. Live rock carries the bacteria and small organisms that keep the system stable, and if it dries out or cools too much, it can die back and release waste that causes an ammonia spike.
The equipment is more complex too. Most reef tanks run a sump with a protein skimmer, return pump, heaters, dosing pumps and sometimes reactors and controllers, all plumbed into the display tank. Everything has to be drained, packed and reassembled correctly.
Planning before the move
Good planning starts weeks ahead. Decide whether the tank will be set up the same day or whether livestock needs to go into temporary holding for a day or two. Check the floor at the new address can take the weight of the full system, including the sump. Arrange the electrical sockets and position for the cabinet so there is no delay on the day.
Mix a quantity of fresh salt water at the new address a day or two before, at the correct salinity and temperature, so it is ready to top up the saved water.
- Confirm floor strength and position at the new address
- Mix fresh salt water in advance at matched salinity
- Plan temporary holding if same-day set-up is not possible
- Test water parameters before the move for reference
- Prepare insulated boxes, bags, oxygen and heated containers
- Photograph the aquascape so it can be rebuilt
On the day: order of work
The crew starts by removing the corals, usually bagging each piece individually or in small groups in tank water, then packing them upright in insulated boxes. Fish are caught and bagged next, then invertebrates. Live rock goes into lidded containers of tank water with heaters or insulation to keep it warm. A portion of tank water is saved in clean containers.
Only then is the display drained, the sand removed and the sump emptied. Equipment is cleaned of loose debris but not sterilised, because the bacteria living on surfaces are valuable.
| Item | How it travels | Key risk |
|---|---|---|
| Corals | Individual bags in insulated boxes | Temperature drop and physical damage |
| Fish | Bags with oxygen or aerated containers | Stress and poor water quality |
| Live rock | Submerged in heated or insulated containers | Die-off if dried or chilled |
| Sand bed | Bagged separately or replaced | Releases waste when disturbed |
| Sump and equipment | Drained, padded and boxed | Damage to pumps and skimmer |
Setting the system back up
At the new address, the cabinet is levelled, the tank and sump are placed and the plumbing is reconnected and leak-tested with saved water. The live rock goes back first, rebuilt to match the original aquascape as closely as possible. The tank is then filled with a mix of saved and prepared salt water, and heaters and pumps are restarted.
Once temperature and salinity match the transport water, livestock is acclimatised slowly and returned. Corals go back in their original positions where possible, because moving them to different lighting or flow can stress them.
Sand beds: keep or replace?
An established sand bed holds trapped waste. When it is disturbed during a move, that waste can be released into the water and cause a spike in ammonia or nutrients. Many reef keepers choose to rinse the old sand thoroughly or replace part or all of it with new sand during a move. This is a judgement call based on the age and depth of the sand bed and the sensitivity of the livestock, and it is worth discussing with your mover beforehand.
Common reef moving mistakes
The most damaging mistake is letting temperature fall. Corals and many reef invertebrates come from warm, stable water, and a long cold carry or a vehicle without insulation can cause tissue loss within hours. Insulated boxes, heat packs where needed and a tight timetable all help. The second is a mismatch in salinity between the saved water, the new salt water and the transport bags, which shocks livestock when it goes back in. Measure salinity at each stage rather than assuming.
Another common problem is restarting the system too fast. Turning on full lighting immediately can stress corals that have spent hours in the dark, and adding all the livestock before the plumbing has been leak-tested risks a flood with animals already in the tank. Test the plumbing with saved water first, then add livestock in stages.
Finally, avoid changing the aquascape or adding new equipment at the same time as the move. Keeping conditions as close to the original as possible gives the system its best chance to settle quickly.
After the move
Expect some coral stress in the first days: polyps may stay closed and colours may dull briefly. Keep lighting at a reduced intensity or shorter duration for a few days, feed lightly and test ammonia, nitrite, nitrate, alkalinity and salinity often. Run the skimmer and carry out small water changes if readings rise. Most well-moved reef systems stabilise within a week or two, though some sensitive corals take longer to recover fully.
Questions people also ask
How much does it cost to move a reef tank?
Marine and reef system moves start from £650. The price covers coral handling, livestock transport, sump and equipment packing, and salt water preparation. Larger systems, bespoke cabinets, difficult access or long distances increase the cost, and big reef aquariums are usually quoted after a survey.
Will my corals survive a move?
Most do when the move is planned well. Bagging corals individually, keeping them warm and dark in insulated boxes, minimising time out of the tank and acclimatising them carefully all improve survival. Some sensitive species show stress for a few days, so reduce lighting and monitor water quality closely.
Can I reuse my live rock after moving?
Yes, as long as it stays submerged or wet and warm during the move. Live rock carries beneficial bacteria and small organisms that help the system stabilise. If it dries out or gets cold, some organisms will die and may cause an ammonia spike, so handle it with care.
Written and checked by the Fish Tank Movers team. Read our editorial policy.
More guides
How Much Does It Cost to Move a Fish Tank in the UK?
Moving a small freshwater tank of up to 120 litres locally typically costs £150–£280. A medium tropical tank of 120–300 litres costs £280–£550, and a…
How to Move a Fish Tank Safely: Step by Step
Stop feeding the fish a day before, bag them in their own tank water with air, and save the filter media in tank water to keep the bacteria alive.…
Fish Tank Movers vs DIY: Should You Move It Yourself?
A small freshwater tank of up to about 60 litres is a reasonable DIY job if you have help, buckets, fish bags and a plan. Larger tanks, marine and…
How to Move Pond Fish and Koi Safely
Move pond fish in spring or autumn when water temperatures are moderate. Lower the water level, net fish gently, and hold them in large aerated tubs…
Get a free fish tank movers quote
Tell us what you need and we'll come back with a clear price.
Request a quote